TP-Link TL-SG116P Brugsanvisning
Her er TP-Link TL-SG116P (Skifte) brugervejledning. 4 sider på sprog Engelsk med en vægt på 0.3 Mb. Hvis du ikke kan finde svar på dit problem Spørg vores community.
Side 1/4
Connection
© 2023 TP-Link 7106510236 REV4.2.1
Installation Guide
5/6/16-Port Gigabit Desktop PoE Switch
LED Explanation
Note: For simplicity, we will take TL-SG1005P for example throughout this Guide.
Note:
1. PoE ports can also connect to non-PoE devices, but only transmit data.
2. TL-SG1005LP can supply up to 30 W for each PoE port and 40 W for all PoE ports.
3. TL-SG1005P can supply up to 30 W for each PoE port and 65 W for all PoE ports.
4. TL-SG1006PP can supply up to 60 W for port 1, 30W for other single PoE port, and 64 W
for all PoE ports.
5. TL-SG116P can supply up to 30 W for each PoE port and 120 W for all PoE ports.
DC Power Adapter
AC Power Cord
IP Camera AP IP Phone
Router
LAN Port WAN Port
Internet
Ethernet Ports (1-5)
PoE Ports (1-4)
Power
On: Power on
O: Power o
Power
Link/Act and PoE Status
On: Providing PoE power
Flashing: Current-overload/Short-circuit
O: Not providing PoE power
On (Green): Connected to a 1000 Mbps
device
On (Yellow): Connected to a 10/100
Mbps device
Flashing: Transmitting/receiving data
O: No device is connected to the
corresponding port.
PoE MAX
PoE Max
TL-SG1005LP
On: 33 W ≤ Total power supply < 40 W
Flashing: Total power supply ≥ 40 W
O: Total power supply < 33 W
TL-SG1005P
On: 58 W ≤ Total power supply < 65 W
Flashing: Total power supply ≥ 65 W
O: Total power supply < 58W
TL-SG116P
On: Total power supply ≥ 113 W
Flashing: Total power supply ≥ 113 W and
lasts for more than 2 minutes
O: Total power supply < 113W
PoE Devices
Switches Explanation
Priority (for TL-SG116P)
O: All the ports transmit data with the same priority.
On: The corresponding ports transmit data with a higher priority than other ports. When congestion
occurs, packets which are transmitted by the ports with a higher priority occupy the whole bandwidth.
Isolation (for TL-SG116P)
O: Ports can transmit data with each other.
On: The corresponding ports cannot transmit data with other downlink ports. They can transmit data
only with the uplink ports (ports 15-16 of TL-SG116P).
Extend (for TL-SG1005P/TL-SG1006PP/TL-SG116P)
O: The corresponding ports run at 10/100/1000 Mbps and support PoE power supply up to 100 m away.
On: The corresponding ports run at 10 Mbps and support PoE power supply up to 250 m away.
Recovery (for TL-SG1005P/TL-SG1006PP/TL-SG116P)
O: The PoE Auto Recovery function is disabled.
On: The switch will constantly detect the working status of a PoE powered device (PD). When the switch
nds that the PD works abnormally, the switch will reboot it.
Note: The numbers in brackets indicate the ports where the feature takes eect. For example, when Extend(1-4) is toggled to On, the Extend mode will be enabled for ports 1-4.
TL-SG1006PP
On: 57 W ≤ Total power supply < 64 W
Flashing: Total power supply ≥ 64 W
O: Total power supply < 57W
Problemløsning TP-Link TL-SG116P
Hvis du har læst manualen omhyggeligt, men ikke fundet en løsning på dit problem, bed andre brugere om hjælp
Specifikationer
| Vekselstrømsindgangsspænding: | 220 V |
| Vekselstrømsindgangsfrekvens: | 50 Hz |
| Bredde: | 286 mm |
| Dybde: | 111.7 mm |
| Højde: | 25.4 mm |
| Produktfarve: | Sort |
| Pakkevægt: | 2000 g |
| Pakkedybde: | 434 mm |
| Pakkebredde: | 227 mm |
| Pakkehøjde: | 70 mm |
| Opbevaringstemperatur (T-T): | -40 - 70 °C |
| Relativ luftfugtighed ved drift (H-H): | 10 - 90 % |
| Relativ luftfugtighed ved opbevaring (H-H): | 5 - 90 % |
| Strømforbrug (typisk): | 11.72 W |
| Driftstemperatur (T-T): | 0 - 40 °C |
| Husmateriale: | Metal |
| Hurtig start guide: | Ja |
| Strømforbrug (maks.): | 144.28 W |
| Netværksstandarder: | IEEE 802.1Q, IEEE 802.1p, IEEE 802.3, IEEE 802.3ab, IEEE 802.3u |
| Servicekvalitet support (QoS): | Ja |
| LED-indikatorer: | Ja |
| Kan monteres på væggen: | Ja |
| DC indgangsspænding: | 9 V |
| Indgangsstrøm: | 0.6 A |
| Fuld duplex: | Ja |
| Strøm over Ethernet (PoE): | Ingen |
| Switch-type: | Ikke administreret |
| Auto MDI/MDI-X: | Ja |
| VLAN understøttelse: | Ja |
| Flowkontrol support: | Ja |
| Port-spejlning: | Ja |
| Antal VLAN'er: | 32 |
| Link aggregering: | Ja |
| Kobber ethernet kabelteknologi: | 10BASE-T, 100BASE-TX, 1000BASE-T |
| Broadcast stormkontrol: | Ja |
| Vituelle LAN funktioner: | Protocol-based VLAN, Tagged VLAN |
| Basis omskiftning RJ-45 Ethernet porte, antal: | 16 |
| Basis omskiftning RJ-45 Ethernet porttype: | Gigabit Ethernet (10/100/1000) |
| IGMP snooping: | Ja |
| Loop beskyttelse: | Ja |
| Opbevar-og-frem: | Ja |
| MAC adresselabel: | 8000 entries |
| Switch kapacitet: | 32 Gbit/sek. |
| Antal køer: | 4 |
| Jumbo Frames support: | Ja |
| Jumbo rammer: | 9000 |
| Varmeafgivelse: | 490.55 BUT/t |
| Gigabit Ethernet (kobber) porte, antal: | 16 |
| Begrænsning af hastighed: | Ja |
| Strømforsyning inkluderet: | Ja |
| Stabelbar: | Ja |
| Auto-forhandling: | Ja |
| Pakke bufferlager: | 4.1 MB |
| Hastighed for videresendelse: | 23.81 Mpps |
| Understøttede kabeltyper: | Cat3, Cat4, Cat5, Cat5e, Cat6 |
| Kabellængde opdagelse: | Ja |