Pioneer
                        
                        Ikke kategoriseret
                        
                        CA-HM-OIS.001
                    
                    Pioneer CA-HM-OIS.001 Brugsanvisning
Her er Pioneer CA-HM-OIS.001 (Ikke kategoriseret) brugervejledning. 8 sider på sprog Engels med en vægt på 0.6 Mb. Hvis du ikke kan finde svar på dit problem Spørg vores community.
                                Side 1/8
                            
                            
                            
WARNING
To reduce the risk of fire or electric shock, do 
not expose this apparatus to rain or 
moisture.
To reduce the risk of fire, do not cover the 
ventilation of the apparatus with newspapers, 
tablecloths, curtains, etc. And do not place lighted 
candles on the apparatus.
To reduce the risk of fire or electric shock, do not 
expose this apparatus to dripping or splashing, 
and do not place objects filled with liquids, such 
as vases, on the apparatus.
Do not install the appliance in a confined space, 
such as a bookcase or built-in cabinet.
Do not expose the batteries (battery pack or 
batteries installed) to excessive heat such as 
sunshine, fire or the like for a long time.
As the main plug is used to disconnect the unit 
from the mains, connect the unit to an easily 
accessible AC outlet. Should you notice an 
abnormality in the unit, disconnect the main plug 
from the AC outlet immediately.
The unit is not disconnected from the AC power 
source (mains) as long as it is connected to the 
wall outlet, even if the unit itself has been turned 
off.
The nameplate and important information 
concerning safety are located on the bottom 
exterior.
CAUTION
Danger of explosion if battery is incorrectly 
replaced. Replace only with the same type.
Notice for customers: the following 
information is only applicable to equipment 
sold in countries applying EU directives
The manufacturer of this product is Sony 
Corporation, 1-7-1 Konan Minato-ku Tokyo,  
108-0075 Japan. The Authorized Representative 
for EMC and product safety is Sony Deutschland 
GmbH, Hedelfinger Strasse 61, 70327 Stuttgart, 
Germany. For any service or guarantee matters 
please refer to the addresses given in separate 
service or guarantee documents.
Precautions
Operate the unit on the power source specified 
in “Specifications.”
Since a strong magnet is used for the speaker, 
keep personal credit cards using magnetic coding 
or spring-wound watches away from the unit to 
prevent possible damage from the magnet.
Do not leave the unit in a location near a heat 
source such as a radiator or airduct, or in a 
place subject to direct sunlight, excessive dust, 
mechanical vibration, or shock.
Allow adequate air circulation to prevent internal 
heat build-up. Do not place the unit on a surface 
(a rug, a blanket, etc.) or near materials (a 
curtain) which might block the ventilation holes.
Should any solid object or liquid fall into the unit, 
unplug the unit and have it checked by qualified 
personnel before operating it any further.
To clean the casing, use a soft cloth dampened 
with a mild detergent solution.
Never touch the wire of the external FM aerial 
during a thunderstorm. Furthermore, 
immediately disconnect the AC power cord 
from the radio.
NOTES ON LITHIUM BATTERY
Wipe the battery with a dry cloth to assure a 
good contact.
Be sure to observe the correct polarity when 
installing the battery.
Do not hold the battery with metallic tweezers, 
otherwise a short-circuit may occur.
Disposal of Old Electrical & 
Electronic Equipment (Applicable 
in the European Union and other 
European countries with separate 
collection systems)
This symbol on the product or on its packaging 
indicates that this product shall not be treated as 
household waste. Instead it shall be handed over 
to the applicable collection point for the recycling 
of electrical and electronic equipment. By 
ensuring this product is disposed of correctly, you 
will help prevent potential negative consequences 
for the environment and human health, which 
could otherwise be caused by inappropriate waste 
handling of this product. The recycling of 
materials will help to conserve natural resources. 
For more detailed information about recycling of 
this product, please contact your local Civic 
Office, your household waste disposal service or 
the shop where you purchased the product.
Applicable accessory: Remote Commander.
Disposal of waste batteries 
(applicable in the European 
Union and other European 
countries with separate 
collection systems)
This symbol on the battery or on the packaging 
indicates that the battery provided with this 
product shall not be treated as household waste.
On certain batteries this symbol might be used in 
combination with a chemical symbol. The 
chemical symbols for mercury (Hg) or lead (Pb) 
are added if the battery contains more than 
0.0005% mercury or 0.004% lead.
By ensuring these batteries are disposed of 
correctly, you will help prevent potentially 
negative consequences for the environment and 
human health which could otherwise be caused 
by inappropriate waste handling of the battery. 
The recycling of the materials will help to 
conserve natural resources.
In case of products that for safety, performance or 
data integrity reasons require a permanent 
connection with an incorporated battery, this 
battery should be replaced by qualified service 
staff only.
To ensure that the battery will be treated properly, 
hand over the product at end-of-life to the 
applicable collection point for the recycling of 
electrical and electronic equipment.
For all other batteries, please view the section on 
how to remove the battery from the product 
safely. Hand the battery over to the applicable 
collection point for the recycling of waste 
batteries.
For more detailed information about recycling of 
this product or battery, please contact your local 
Civic Office, your household waste disposal 
service or the shop where you purchased the 
product.
If you have any questions or problems concerning 
your unit, please consult your nearest Sony dealer.
Features
Compatible with iPod/iPhone
Wake or Sleep to iPod/Radio/Buzzer
Easy to set A-B alarm
2-5-7day alarm
LCD Brightness control
MEGA BASS
MEGA Xpand
Wireless Remote Commander
Specifications
Time display
24-hour system
Section for iPod
DC out: 5V
MAX: 500mA
Radio section
Frequency range
Band Frequency Channel 
step
FM 87.5 MHz – 108 MHz 0.05 MHz
AM 531 kHz – 1 602 kHz 9 kHz
General
Speaker
Approx. 5.7 cm (2 1/4 inches) dia. 6 Ω
Input
AUDIO IN jack (ø 3.5 mm stereo minijack)
Power output
3.5 W + 3.5 W (at 10% harmonic distortion)
Power requirements
230 V AC, 50 Hz
For clock back up: 3V DC, CR2032 battery (1)
Dimensions
Approx. 290.5 mm × 152.0 mm × 139.5 mm (w/h/d)  
(11 3/8 inches × 5 15/16  inches × 5 1/2 inches)  
including projecting parts and controls
Mass
Approx. 2.0 kg (4 lb 7 oz) including power supply 
unit
Supplied accessories
Remote commander (1)
AM loop aerial (1)
Audio connecting cable (1)
Universal Dock Adapter for iPhone (1)
Universal Dock Adapter for iPhone 3G & iPhone 
3GS (1) 
Universal Dock Adapter for iPhone 4 (1)
Design and specifications are subject to change 
without notice.
Compatible iPod/iPhone 
models
Compatible iPod/iPhone models are as follows. 
Update your iPod/iPhone to use the latest 
software before you use it.
iPod touch  
1st generation
iPod nano  
3rd generation 
(video)
iPod  
5th generation  
(video)
iPod classic
iPhone 3GS
iPod touch  
3rd generation
iPod nano
5th generation  
(video camera) 
iPod nano  
2nd generation 
(aluminum)
iPod  
4th generation  
(color display)
iPod mini 
iPhone 3G
iPod touch
2nd generation
iPod nano
4th generation  
(video)  
iPod nano  
1st generation
iPod  
4th generation 
iPhone 4
iPhone
Notes
In these Operating Instructions, “iPod” is used 
as a general reference to functions of iPod on an 
iPod or iPhone, unless otherwise specified by 
the text or illustrations.
The connector of the unit is for sole use with an 
iPod. If you use devices that do not match with 
the connector, connect to the AUDIO IN jack of 
this unit with the supplied audio connecting 
cable.
Sony cannot accept responsibility in the event 
that data recorded to an iPod is lost or damaged 
when using an iPod connected to this unit.
Troubleshooting
Should any problem persist after you have made 
the following checks, consult your nearest Sony 
dealer.
The clock flashes “0:00” due to a power 
interruption.
The battery is low. Replace the battery. Remove 
the old battery and install a new one.
The alarm of radio, iPod or buzzer does not 
sound at the preset alarm time.
Check that alarm “A” or alarm “B” is properly 
displayed. 
The alarm of radio or iPod is activated but no 
sound comes on at the preset alarm time.
Check the alarm volume setting.
There is no sound from the iPod.
Make sure the iPod is securely connected.
Adjust the VOLUME.
The iPod cannot be operated with this unit.
Make sure the iPod is securely connected.
The iPod cannot be charged.
Make sure the iPod is securely connected.
4-150-697- (1)42 Notes
Do not attempt to charge the battery.
If you are not going to use the remote 
commander for a long time, remove the battery 
to avoid any damage that may be caused by 
leakage and corrosion.
About the backup 
battery
To keep accurate time, this unit contains a 
CR2032 battery as a backup power source.
The battery keeps the clock and the alarm 
operating in the event of a power interruption.
Note for customers in Europe
The clock is preset at the factory, and its memory 
is powered by the preinstalled Sony CR2032 
battery. If the “0:00” appears in the display when 
the unit is connected to AC outlet for the first 
time, the battery may be weak. In this case, 
consult a Sony dealer. The preinstalled CR2032 
battery is considered part of the product, and is 
covered by the warranty. 
You are required to show “Note for customers in 
Europe” (in this instruction) to a Sony dealer in 
order to validate the warranty for this product.
To know when to replace the 
battery
When the battery becomes weak, “ ” appears in 
the display.
If a power interruption occurs while the battery is 
weak, the current time and alarm will be erased.
Replace the battery with a Sony CR2032 lithium 
battery. Use of another battery may cause a fire or 
explosion.
To replace the battery
1  Keep the AC plug connected to the AC 
outlet, remove the screw that secures the 
battery compartment lid at the bottom of 
the unit using a screwdriver, and open 
the lid (see Fig.  ).
2  Insert a new battery in the battery 
compartment with the   side facing up 
(see Fig.  ).
3  Close the battery compartment lid and 
secure it with the screw (see Fig.  ).
4  Press iPod & iPhone  RADIO   ,
BAND  AUDIO IN   SNOOZE/DATE/, or
SLEEP OFF   to turn “ ” off in the 
display.
Note
When you replace the battery, do not disconnect 
the plug from the AC outlet. Otherwise, the 
calendar, current time, alarm and station presets 
will be erased.
Reset button
CR2032
When Daylight Saving Time (summer time) 
begins, the clock does not employ the 
Daylight Saving Time automatically.
Make sure the clock is set correctly.
Press and hold CLOCK and SNOOZE/DATE/
SLEEP OFF simultaneously for at least  
2 seconds to activate the Automatic DST 
function.
Connecting the aerial
To connect the AM loop 
aerial
The shape and the length of the aerial is designed 
to receive AM signals. Do not dismantle or roll up 
the aerial.
1  Remove only the loop part from the 
plastic stand.
2  Set up the AM loop aerial.
3  Insert the AM aerial terminal into the 
AM ANTENNA jack on the rear of the 
unit.
To remove the AM loop aerial
Pull the AM aerial terminal while pushing up the 
terminal clamp.
Adjusting the AM loop aerial
Find a place and an orientation that provide good 
reception.
Do not place the AM loop aerial near the unit 
or other AV equipment, as noise may result.
Tip
Adjust the direction of the AM loop aerial for best 
AM broadcast sound.
Preparing the remote 
commander
Before using the remote commander for the first 
time, remove the insulation film.
To know when to replace the 
battery 
With normal use, the battery (CR2025) should 
last for about six months. When the remote 
commander no longer operates the unit, replace 
the battery with a new one.
CR2025
If the time in the display is 
incorrect after the battery is 
changed (Reset)
Press the reset button with a pointed device. The 
reset button is in the small hole located in the 
battery compartment (see Fig.  ). 
©2010 Sony Corporation          Printed in China
Personal Audio
Docking System
Operating Instructions
ICF-DS11iP
Problemløsning Pioneer CA-HM-OIS.001
Hvis du har læst manualen omhyggeligt, men ikke fundet en løsning på dit problem, bed andre brugere om hjælp
Specifikationer
| Mærke: | Pioneer | 
| Kategori: | Ikke kategoriseret | 
| Model: | CA-HM-OIS.001 |