GE JSP46DNBB Brugsanvisning
Her er GE JSP46DNBB (Komfur) brugervejledning. 20 sider på sprog Engelsk med en vægt på 1.2 Mb. Hvis du ikke kan finde svar på dit problem Spørg vores community.
Side 1/20
1
MATERIALS YOU MAY NEED
3-Wire Cord
4’ long
(UL Approved 40 or 50 AMP)
Lag Bolts Anchor Sleeves
(For Anti-Tip Bracket Mounted
on Concrete Floors Only)
4-Wire Cord
4’ long
OR
If you have questions, call 1.800.GE.CARES or visit our website at:
ge.com
Self-Cleaning Radiant
Electric Slide-In Range
Installation
Instructions JSP42, JS968, JS900, JS905, JSP46
31-10621-3 09-08 JR
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT—Save these
instructions for local inspector’s use.
• IMPORTANT—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE—This appliance must be properly
grounded.
PARTS INCLUDED
Anti-Tip BracketScrews
Rear Filler
2 Screws
TOOLS YOU WILL NEED
1/8” Drill Bit and
Electric or Hand Drill
1/4” Nut Driver
Level
Tape Measure
Straight Edge
or Square
Hand or Sabre Saw
Pencil
Safety Glasses
Wrench or Pliers
(for 1-7/16 Nut)”
Pliers
Tin Snips
Squeeze Connector
(For Conduit
Installations Only)
Problemløsning GE JSP46DNBB
Hvis du har læst manualen omhyggeligt, men ikke fundet en løsning på dit problem, bed andre brugere om hjælp
Specifikationer
| Mærke: | GE |
| Kategori: | Komfur |
| Model: | JSP46DNBB |